For on-site machining and rehabilitation of embedded parts during the assembly phase, corrective maintenance and repowering.

For In-situ rehabilitation through machining, grinding and welding in diameter ranges 1,500 to 12,000 mm of:

Support flanges and union of the upper cover

Ante-distributor flange

Upper surface of the lower cap

For on-site machinings with diameter ranges 1,500 to 4,000 mm of:

Embedded flanges for suction tubes and spiral chambers.

For on-site rehabilitation by machining of :

Frames, guides, gates and embedded base plates

For on-site machining and rehabilitation of detachable component during the assembly phase, corrective maintenance and repowering.

For rehabilitation on-site through machining, grinding, welding and dynamic balancing of:

For machining of Guide vane bearing housings with covers mounted in place.